MIL-C-48582B (AR)
3.6 First article. When specified in the contract or purchase
order, a sample shall be subjected to first article inspection in
accordance with the technical provisions herein (see 4.3) .
3.7 Soldering. All soldering shall be in accordance with the
general requirements of MIL-STD-2000 in addition to detail
requirement (task) F of paragraph 1.2 of MIL-STD-2000.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified
in the contract or purchase order, the contractor is responsible for
the performance of all inspection requirements as specified herein.
Except as otherwise specified in the contract or purchase order, the
contractor may use his own or any other facilities suitable for the
performance of the inspection requirements specified herein, unless
disapproved by the Government. The Government reserves the right to
perform any of the inspections set forth in the specification where
such inspections are deemed necessary to assure supplies and
services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet all
requirements of sections 3 and 5 and all applicable drawings. The
inspections set forth in this specification shall become a part of
the contractor's overall inspection system or quality program. The
absence of any inspection requirements in the specification shall
not relieve the contractor of the responsibility of assuring that
all products or supplies submitted to the Government for acceptance
comply with all requirements of the contract. Sampling in quality
conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the
Government to acceptance of defective material.
4.1.2 General provisions. The component and subassembly
inspection requirements of MIL-F-13926 form a part of the quality
assurance provisions of this specification. Reference shall be made
to MIL-STD-109 to define quality assurance terms used herein.
4.2 Classification of inspections. The inspection requirements
specified herein are classified as follows:
a.
First article inspection (see 4.3).
b.
Quality conformance inspection (see 4.4).
c.
Special sampling inspection (see 4.5).
4.2.1 Inspection conditions. Unless otherwise specified, all
examinations and tests shall be conducted at the following standard
ambient conditions:
Temperature
+50 deg to +90 deg F.
b.
Relative humidity
90% RH Max.
c.
Pressure
28 to 32 inches of Hg.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business