MIL-G-50351A (AR)
3.5.2 FINE DELAY ADJ control (R2). Turning FINE DELAY ADJ
control (R2) from fully counterclockwise to fully clockwise shall
cause the delay of output signal of Table I to vary smoothly from
(fully counterclockwise) to approximately
approximately 1.70
(fully clockwise).
17.10
3.6 First article. When specified in the contract or
purchase order (see 6.2), a sample shall be subjected to first
article inspection in accordance with the technical provisions
herein (see 4.3).
3.7 Soldering. All soldering shall be in accordance with
the requirements of Note 2 of Drawing 12950877.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise
specified in the contract or purchase order, the contractor is
responsible for the performance of all inspection requirements
(examinations and tests) as specified herein. Except as
otherwise specified in the contract or purchase order, the
contractor may use his own or any other facilities suitable for
the performance of the inspection requirements specified herein,
unless disapproved by the Government. The Government reserves
the right to perform any of the inspections set forth in this
specification where such inspections are deemed necessary to
ensure supplies and services conform to prescribed requirements.
4.1.1 Responsibility for comp liance. All items shall meet
all requirements of Sections 3 and 5. The inspection set forth
in this specification shall become a part of the contractor's
overall inspection system or quality program. The absence of any
inspection requirements in the specification shall not relieve
the contractor of the responsibility of ensuring that all
products or supplies submitted to the Government for acceptance
comply with all requirements of the contract.
Sampling
inspection, as part of manufacturing operations, is an acceptable
practice to ascertain conformance to requirements, however, this
does not authorize submission of known defective material, either
indicated or actual, nor does it commit the Government to accept
defective material.
4.1.2 General provisions.
Unless otherwise specified
herein, the provisions of MIL-F-13926 apply and form a part of
Reference shall be made to MIL-STD-109 to
this specification.
define quality assurance terms used herein.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business